SimpleTech ZeusIOPS User Manual Page 29
- Page / 84
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Zeus
IOPS
3.5-Inch Fibre Channel Solid State Drive Product Manual Rev. 1.0 29
GROUNDING
Signal and chassis ground are not connected together in the drive. To ensure minimal EM emissions,
the user should provide maximum surface contact area when connecting the drive to chassis ground.
FAULT LED OUT SIGNAL
The Fault LED Out signal is driven by an open collector driver capable of sinking 30mA. It is driven
low when an internal fault is detected along with both Enable Bypass signals.
READY LED OUT SIGNAL
The Ready LED Out signal is driven by an open collector driver capable of sinking 30mA. It will
typically be connected to the cathode of an LED in the enclosure. The Ready LED function is nearly
identical to the SFF-8045 specification for hot-plugging implementations; however, since the drive
has no motor, it behaves as follows:
• Drive not mated:
The signal is de-asserted (i.e., High). The LED is off.
• Drive mated, power-up diagnostics in progress:
The signal is asserted for 1/3 of a second and de-asserted for 2/3 of a second. This
represents a 1Hz Short flash.
• Drive mated, firmware running, drive in progress of becoming ready:
The signal is asserted for one-half second and de-asserted for one-half second. This
represents a 1Hz Normal flash.
• Drive mated, firmware running and drive ready:
The signal is asserted when either of the loops is brought up. The signal will de-assert when
the drive is active on either of the fibre loops.
-PARALLEL ESI AND SEL_n/P_ESI_n
SEL_n/P_ESI_n are a set of dual purpose pins that are used to convey either a Loop Identifier
address or Enclosure Service Information (where this is supported by the backplane) to the SSD.
-Parallel ESI determines the function of Sel_n/-P_ESI_n. It is a TTL open-drain output from the SSD.
When -Parallel ESI is de-asserted (high), the backplane must present SEL_ID information on SEL_n/
P_ESI_n. See SEL_ID Function.
When -Parallel ESI is asserted (low), the backplane must present Enclosure Service Information (if
supported) on SEL_n/P_ESI_n. See SEL_ID Function on page 16.
Note: The maximum response time to a change in state of -Parallel ESI is 1μS.
- Fibre Channel 1
- 3.5-Inch Solid State Drive 1
- Product Manual 1
- Trademark Information 2
- Disclaimer of Liability 2
- Copyright Notice 2
- MANUAL CONVENTIONS 3
- REVISION HISTORY 5
- TABLE OF CONTENTS 7
- LIST OF TABLES 13
- LIST OF FIGURES 15
- MANUAL OVERVIEW 17
- PRODUCT IDENTIFICATION CODES 17
- AUDIENCE 18
- NSTALLATION 19
- EGULATORY COMPLIANCE 19
- IBRE CHANNEL STANDARD 19
- STANDARD FEATURES 20
- NVIRONMENTAL CHARACTERISTICS 22
- PRODUCT DESCRIPTION 23
- PERFORMANCE CHARACTERISTICS 24
- MOUNT TIME 25
- ACCESS TIME 25
- DATA TRANSFER RATES 25
- ERASE TIMES 26
- SANITIZE 26
- CACHE OPERATIONS 27
- HOT PLUGGING 27
- PREVENTATIVE MAINTENANCE 27
- ELECTRICAL SPECIFICATIONS 28
- GROUNDING 29
- FAULT LED OUT SIGNAL 29
- READY LED OUT SIGNAL 29
- SEL_ID FUNCTION 30
- P_ESI_n FUNCTION 31
- START_n MATED 31
- -DRIVE PRESENT 32
- DEV_CTRL_CODE_X 32
- INTERFACE SPECIFICATIONS 33
- SCSI INTERFACE BLOCK 34
- SCA-2 INTERFACE CONNECTOR 34
- CONNECTOR LOCATION 35
- VOLTAGE AND GROUND SIGNALS 36
- FC-AL FEATURES 37
- FCP-SCSI COMMANDS 38
- EST UNIT READY COMMAND (00h) 40
- EAD (6) COMMAND (08h) 40
- . Byte 5 is ignored 41
- ODE SENSE (6) COMMAND (1Ah) 43
- SEND DIAGNOSTIC PAGE(1Dh) 44
- OG SENSE COMMAND (4Dh) 45
- READ CAPACITY (25h) 46
- Table 23. Read Capacity CDB 46
- READ EXTENDED (10) (28h) 47
- RITE EXTENDED (10) (2Ah) 48
- RITE AND VERIFY (10) (2Eh) 48
- ERIFY (10) (2Fh) 48
- RITE BUFFER COMMAND (3Bh) 49
- YNCHRONIZE CACHE (10) (35h) 49
- ODE SENSE (10) COMMAND (5Ah) 50
- UNSUPPORTED COMMANDS 52
- FIBRE CHANNEL STANDARD 53
- FABRIC NODE CONNECTION 55
- Table 32. FCP Function Levels 57
- PHYSICAL CHARACTERISTICS 58
- EXTERIOR DIMENSIONS 59
- ENVIRONMENTAL CHARACTERISTICS 60
- AXIMUM COMPONENT TEMPERATURES 61
- INSTALLATION 62
- DRIVE CONFIGURATION 63
- FAULT SIGNALS 63
- OWER-ON FAULT CONDITIONS 64
- PERATIONAL FAULT CODES 65
- DRIVE ORIENTATION 67
- COOLING REQUIREMENTS 68
- MOUNTING HOLE DIMENSIONS 69
- DRIVE INSTALLATION 70
- GROUNDING REQUIREMENTS 70
- MICROSOFT OS COMPATIBILITY 71
- SSD MANAGEMENT UTILITY 72
- NAND FLASH SUPPORT 73
- REGULATORY COMPLIANCE 74
- RADIO FREQUENCY EMISSIONS 75
- EMI TEST SITE CORRELATION 75
- VERIFICATION SAMPLES 75
- VERIFICATION TESTING 75
- ELECTROSTATIC DISCHARGE (ESD) 76
- Contact Information 77
- Ordering Information 77
- 78 Zeus 80
- 80 Zeus 82
- CERTIFICATION AND WARRANTY 83
- 61000-04522-101: Revision 1.0 84
Pelco DD5T manuels
Manuels d'utilisation et guides de l'utilisateur pour Caméras de sécurité Pelco DD5T.
Nous fournissons des manuels en pdf 1 Pelco DD5T à télécharger gratuitement par type de document : Manuel de l'utilisateur
Pelco DD5T Manuel de l'utilisateur (20 pages)
marque: Pelco | Catégorie: Security cameras | Taille: 0.15 MB |
Table des matières
CONTENTS
2
CAUTION:
4
Limit Stops
10
SENSITIVE
12
GAIN/AGC
13
AGC Mode
13
AUTO IRIS
13
SHARPNESS
15
AUTO FLIP
16
LIMIT STOPS
16
Plus de produits et de manuels pour Caméras de sécurité Pelco
| Modèles | Type de document |
|---|---|
| C1510M-QS |
Manuel de l'utilisateur
Pelco C1510M-QS User's Manual,
61 pages
|
| KBD300V |
Manuel de l'utilisateur
Pelco KBD300V User's Manual,
16 pages
|
| c2408M-F(4/03) |
Manuel de l'utilisateur
Pelco c2408M-F(4/03) User's Manual,
12 pages
|
| EH3512 |
Manuel de l'utilisateur
Pelco EH3512 User's Manual,
8 pages
|
| EH4700 |
Manuel de l'utilisateur
Pelco EH4700 User's Manual,
16 pages
|
| C2444M-C |
Manuel de l'utilisateur
Pelco C2444M-C User's Manual,
49 pages
|
| C1306M-B |
Manuel de l'utilisateur
Pelco C1306M-B User's Manual,
24 pages
|
| FT8301A |
Manuel de l'utilisateur
Pelco FT8301A User's Manual,
36 pages
|
| DD5TA |
Manuel de l'utilisateur
Pelco DD5TA User's Manual,
20 pages
|
| IS90 |
Manuel de l'utilisateur
Pelco IS90 User's Manual,
32 pages
|
| MR5000 |
Manuel de l'utilisateur
Pelco MR5000 User's Manual,
16 pages
|
| Camclosure ICS210 |
Manuel de l'utilisateur
Pelco Camclosure ICS210 User's Manual,
20 pages
|
| DVR C2968M-A |
Manuel de l'utilisateur
Pelco DVR C2968M-A User's Manual,
20 pages
|
| CC3701H-2X |
Manuel de l'utilisateur
Pelco CC3701H-2X User's Manual,
12 pages
|
| Switch C1528M-F |
Manuel de l'utilisateur
Pelco Switch C1528M-F User's Manual,
106 pages
|
| C1306M |
Manuel de l'utilisateur
Pelco C1306M User's Manual,
24 pages
|
| EH4718DB |
Manuel de l'utilisateur
Pelco EH4718DB User's Manual,
16 pages
|
| C2941M |
Manuel de l'utilisateur
Pelco C2941M User's Manual,
24 pages
|
| C2410M-J |
Manuel de l'utilisateur
Pelco C2410M-J User's Manual,
12 pages
|
| C3426M-D |
Manuel de l'utilisateur
Pelco C3426M-D User's Manual,
36 pages
|
© 2020, manymanuals.com. All rights reserved. | 0.029 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals